RemoteTx Manual
remotetx.net

Radio link (EC button)

The radio link joins EasyConnect to the radio you're operating in RemoteTx. The RemoteTx page in your browser connects to EasyConnect over a local WebSocket (ws://127.0.0.1:12700) and passes frequency, mode and transmit state both ways.

Linking#

  1. Start EasyConnect on the same computer as your browser.
  2. In RemoteTx, open the Radio tab and connect the radio.
  3. Click EC, next to the VFO, PTT and CW buttons. It turns red when linked.
  4. In EasyConnect, the Radio link pill turns green and shows the radio type, e.g. Radio link: icom-scope.

If Chrome asks whether the RemoteTx site may access devices on your local network, allow it.

Right-click EC to change the address, if you changed the Radio link host / port in EasyConnect. The EC button isn't shown on iPhone or iPad.

What follows what#

You do thisResult
Tune, change mode, or key TX from N1MM or WSJT-XThe radio follows.
Turn the radio's knob, change its mode, or key itLoggers follow (EasyConnect pushes the change through auto-information IF…;).
Change the frequency in EasyConnect's Radio stateThe radio and loggers follow.
The browser page closes or loses the link while transmittingEasyConnect drops to RX.
ℹ️Note

The FT8 tab also reaches EasyConnect through this link. FT8 to loggers needs EC on, even if you don't use CAT.

© RemoteTx® · remotetx.net · Manual built 2026 · Updated 2026-11-19